Wolf · Lexington, MA
Oven Repair
Built-in wall ovens and the cavities beneath Wolf ranges, single and double. Heating elements, igniters, thermostats, door hinges and cooling fans are where nearly all of these end up.
Flat $95 service call, credited against the repair once approved.
On the phone
What people describe
- Long preheat that never reaches temperature
- Broil element glowing at one end only
- Convection fan rattling, or silent altogether
- Display locking on an error and the oven shutting down
On the visit
What gets measured
- Cavity temperature against the set point across a full preheat
- Sensor resistance cold and at heat, to prove or clear a drift
- Bake and broil element continuity, and their condition by eye
- Door hinge tension, gasket seal and glass pack alignment
A quote written before those numbers exist is a guess with a price attached to it.
Cost
Bands, not quotes
Where a job sits inside a band depends on the part, on how far in it is, and on the hours. Your own figure comes after the diagnosis and before any work starts.
- Igniter or spark module replacement
- $290$610
- Burner valve or orifice service
- $250$1,020
- Oven thermostat or sensor calibration
- $140$700
- Convection fan or motor
- $320$940
- Control board or touch panel
- $530$1,530
- Door hinge, glass or seal
- $210$990
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it.
A comparable new appliance is $6,900 to $17,760 for the unit alone — no delivery, no installation, no cabinetry. That gap is why most of the bands above are still the cheaper answer.
Where
Oven Repair across the round
The other three pages, written the same way:
After a oven repair call
4.9 out of 5 · 559 reviews
-
5 out of 5
The convection fan started rattling and then went silent altogether. Motor bearing had collapsed. He fitted a new motor, cleaned the baffle behind it, and checked airflow across both racks before calling it done.
Jarrah L. · East Lexington
-
5 out of 5
The broil element glowed at one end only. He replaced it and found a scorched connector at the rear that would have failed next, so he changed that too and explained why. Both cavities heat evenly now.
Hattie V. · Lexington Center
-
5 out of 5
Display locked on an error mid roast and the unit shut down. He read the fault code rather than guessing, found a failed relay and replaced the board.
Cressida P. · Meriam Hill
Book the visit
Describe what the oven is doing.
Flat $95 service call, credited against an approved repair. Vans out 8:00 am – 8:00 pm, seven days; the phone is answered 24/7.
